#Show mac address table command full#

session prompt default 'sw1->' changes it to 'sw1->'. Uptime, date, name, contact, location: show system Show CMM (Control Management Module – Alcatel ) information: show cmm System To monitor the health of the system: show health all (cpu|memory) Get info about the chassis: show chassis and about the stack: show stack topology. If the primary disappears, the secondary becomes primary and the first idle becomes secondary. When stacking is operational, one switch is primary, one other secondary, the others idle. To disable an interface: interface / admin down Link Aggregation Dynamic LAG (LACP) If forced in 100FD while autoneg is on, the port will stay down To switch from autonegociation to 100FD, set To clear counters: interfaces no l2 statistics Summary of interfaces errors: show interfaces counters errors Info about an interface (admin status, MAC, speed, duplex, errors. To list the ports of a specified vlan: show vlan port.To associate a port to a specific vlan: vlan port default /.vlan router 'interface name' vlan address mask.

ip interface 'interface name' vlan address mask.

show vlan lists all VLANs, show vlan shows vlan details.ĭepending on the microcode version ( show microcode), a layer 3 VLAN is created using: show reload will show you when the switch will reboot.Ī layer 2 VLAN is created with vlan enable name 'vlan name' and removed with no vlan. A reload can be canceled with reload cancel.

It is possible to program the switch to reload a few minutes ahead in case you lose control: reload in where n is the number of minutes to wait before reloading. When modifying the configuration, it can be useful to reload the switch in certified mode if a configuration error occur. view running configuration: show configuration snapshot or write terminal.reboot in working mode without rollback: reload working no rollback-timeout.save running even in certified mode: configuration snapshot all Then move this file to working/boot.cfg.save working -> certified: copy working certified, flash-synchro will synchronize the conf accross all slots.Configuration files are stored in certifed/boot.cfg and working/boot.cfg (they can be directly edited with 'vi'). When booting, if working and certified configuration files are different, the switch will boot in certified mode. In working mode, the configuration can be modified, while it is no possible in certified mode (well, actually, it is). Managing the configuration filesĪlcatel Omniswitchs can operate in two modes: working and certified (show running-directory to know in which mode the switch is).

#Show mac address table command full#

The full documentation can be found on Alcatel-Lucent website. This page is based on the notes I took when managing Alcatel Omniswitchs 6600, 6800 in 2007 and later 6850. īasic commands on Alcatel Omniswitch Introduction Latouche: Basic commands on Alcatel Omniswitch Website of latouche

Show mac address-table command